Hand tool #15 of 15

Brace and bit

by Edward J. Thunderbird

Bores clean holes by hand, with no power at all.

Why choose itWhat it doesHow to use itMaintenanceBuying guideWhere to buy and cost
Brace and bitBoring a hole by hand, no electricity neededLean on the top knob, crank the handleBore from both sides to avoid splintering
Brace and bit in use. Original drawing.

Why choose a brace and bit

Before electric drills, every house was built with a brace. The crank gives a lot of turning force, and an auger bit pulls itself through the wood, boring clean holes up to 1-1/2 inches. A small egg-beater hand drill makes small pilot holes.

Power version: a cordless drill or impact driver.

What it is used for

How to use it

  1. Put the auger bit in the chuck and tighten.
  2. Set the screw point on your mark and lean on the top knob.
  3. Crank clockwise; the bit pulls itself in.
  4. When the point pokes out the other side, finish the hole from that side to avoid splintering.
Safety

Maintenance: keep it working

What to look for when you buy

Where to buy it and what it costs

Typical price: $20 to $80. Three good choices:

Budget

Vintage Stanley or Millers Falls brace (used)

about $20 to $40

Flea markets, eBay, estate sales.

Best value

Vintage brace plus an Irwin auger bit set

about $60 to $110

Look for Irwin or Jennings pattern bits.

Small holes

Egg-beater hand drill

about $20 to $40

For pilot holes.

Shop for any brace and bit

Home DepotLowe'sAmazonAce HardwareHarbor Freight

Prices are typical U.S. store prices checked November 17, 2026. They change often with sales; check the store. Tools Critical is not paid by any store or brand.

← ClampsAll hand toolsClaw hammer →