Hand tool #14 of 15
Clamps
by Edward J. Thunderbird
A third and fourth hand: hold parts while you glue, cut or fasten.
Why choose a clamps
Clamps hold work steady for cutting and drilling, squeeze glue joints tight while they dry, and hold boards in place while you screw or nail them. Woodworkers say you can never have too many.
Power version: none; even pros use clamps.
What it is used for
- Gluing boards into panels
- Holding work on the bench
- Holding a straightedge as a saw guide
- Holding boards in position for fastening
How to use it
- Tighten until a little glue squeezes out; do not crush the joint.
- Use pads or scrap wood to keep jaws from denting the work.
- Alternate clamps above and below a panel to keep it flat.
Safety
- Clamp work instead of holding it with your hand near a blade or bit.
Maintenance: keep it working
- Scrape off dried glue; wax the bars so glue does not stick.
What to look for when you buy
- Start with four 12 inch one-handed bar clamps and two 24 to 36 inch clamps
- Pipe clamps are the cheapest long clamps
- Parallel jaw clamps for cabinets
Where to buy it and what it costs
Typical price: $15 to $60 each. Three good choices:
Budget
Irwin Quick-Grip one-handed bar clamps
about $15 to $25 each
Fast, one hand.
Best value
Pony pipe clamp fixtures plus 3/4 inch black pipe
about $15 to $25 each plus pipe
Any length you want.
Pro
Bessey K-Body parallel clamps
about $40 to $60 each
Square, even pressure.
Shop for any clamps
Prices are typical U.S. store prices checked November 17, 2026. They change often with sales; check the store. Tools Critical is not paid by any store or brand.