Corded vs. battery tools: which has enough power?
Battery tools now do most jobs a corded tool can. But a plug never runs down, and a few tools still work best on a cord. Here is how to tell which you need, tool by tool.
The short answer
| Corded (plug-in) | Battery (cordless) | |
|---|---|---|
| Power | Full power all day: a 15 amp tool uses up to about 1,800 watts | Today's brushless tools with big packs match corded tools for most jobs, for a while |
| Running out | Never, as long as there is power | When the pack is empty you stop and swap; a few minutes of hard work per pack on big saws |
| Convenience | Cord to drag, trip over, and cut; need an outlet | Grab and go: ladders, roofs, fence lines, anywhere |
| Weight | Usually lighter (no battery) | Heavier with a big pack |
| Cost | Cheaper tool, nothing else to buy | Batteries and charger are expensive; cheap once you own a brand's batteries |
| Lifespan | Motor lasts many years | Tool lasts years; batteries wear out in about 3 to 10 years |
| Cold weather | No change | Lithium batteries lose capacity in freezing cold; keep them warm |
| Best for | All-day heavy work in one place: table saw, miter saw, planer, big hammer drills, shop vac | Drills, drivers, circular and recip saws, jigsaws, nailers, multi-tools, anywhere away from power |
Power vs. energy: why a battery tool can feel strong, then quit
Two different things matter. Power is how hard the tool can push right now: whether a saw bogs down in a wet 2x10 or a drill stalls in a big hole. Energy is how long it can keep doing it before the battery is empty.
A corded tool gets power from the motor and wiring (a 15 amp saw on a 120 volt outlet can draw about 1,800 watts) and unlimited energy from the wall. A battery tool can now deliver similar power for short bursts, especially with a brushless motor and a high-output pack, but its energy is limited to what is stored in the pack.
Reading the numbers on a battery
- Volts (V): roughly how much push. 12V is light duty, 18V and "20V MAX" are the same class (20V is the peak, 18V is the nominal), and 36V to 60V packs run big saws, mowers and chainsaws.
- Amp-hours (Ah): the size of the tank. A 5 Ah pack holds 2.5 times what a 2 Ah pack holds.
- Watt-hours (Wh) = volts x amp-hours: the real energy. An 18V 5 Ah pack holds about 90 Wh.
- "High-output" packs use bigger or newer cells that deliver more current with less heat, so saws and grinders bog down less.
- Brushless motors run cooler and get roughly 30 to 50 percent more work out of each charge than older brushed motors.
How long a battery lasts
Real-world rule of thumb: an 18V 5 Ah pack in a brushless circular saw will usually make somewhere around 100 or more crosscuts in 2x4s, but only a few dozen rips in long boards or cuts in thick, wet lumber. A drill driver on the same pack drives hundreds of screws. Having two or three packs and a charger running keeps most crews working all day.
Tool by tool: corded, battery, or either
| Tool | Best choice | Why |
|---|---|---|
| Drill/driver | Battery | Light power draw; one pack lasts a long time. |
| Impact driver | Battery | Almost no corded ones are sold anymore. |
| Circular saw | Either | Battery for framing and job sites; corded for long days of ripping plywood. |
| Reciprocating saw | Either | Battery is handiest for demo and pruning; corded for long cuts in steel or cast iron. |
| Jigsaw | Either | Low power draw; battery is fine. |
| Miter saw | Corded (or either) | It sits in one place near power; corded is cheaper and never runs out. |
| Table saw | Corded | Long rips need steady, full power; battery table saws exist but use packs fast. |
| Sander | Corded (or either) | Sanding runs a long time; corded models are cheaper and lighter. |
| Angle grinder | Either | Battery for quick cuts; corded for hours of grinding or cutting. |
| Multi-tool | Battery | Short jobs in awkward spots. |
| Router | Corded (or either) | Big bits need steady power; small trim routers are fine on battery. |
| Rotary hammer | Either | Battery for anchors and small holes; corded for big holes and chiseling. |
| Framing nailer | Either | Cordless saves the compressor and hose; pneumatic is cheaper, lighter and faster. |
| Chainsaw | Battery or gas | Battery for cleanup and firewood near the house; gas for heavy, all-day cutting far from power. |
| Shop vac | Corded | Big motors drain packs fast; battery vacs are for small cleanups. |
Extension cords: the hidden power thief
A long, thin extension cord drops the voltage, so a corded tool runs weaker and hotter. Use the right size:
| Cord length | For tools up to 10 amps | For 15 amp saws |
|---|---|---|
| Up to 25 ft | 16 gauge | 14 gauge |
| 50 ft | 14 gauge | 12 gauge |
| 100 ft | 12 gauge | 10 gauge (or move closer to power) |
Smaller gauge number = thicker wire. Outdoor cords should be marked for outdoor use (SJTW or SJOOW). Approximate guidance; follow the tool and cord makers' ratings.
Generators, inverters and solar
- A 15 amp saw needs about 1,800 watts running and more for a moment as the motor starts: plan on a generator or inverter of at least 3,000 watts for saws and compressors.
- Use an inverter generator or a pure sine wave inverter for tools with electronic speed control.
- Off-grid and on solar? Battery tools fit perfectly: charge packs from the inverter during the sunny part of the day, and run corded tools when the sun is up and the batteries are full. See solarcritical.com.
- In a power outage, charged tool batteries are a big advantage; many brands sell small inverters and lights that run on the same packs.
Cost: what the batteries really cost
| Item | Typical price |
|---|---|
| 18/20V 2 Ah battery | $40 to $90 |
| 18/20V 5 Ah battery | $80 to $160 |
| High-output 8 to 12 Ah battery | $150 to $300 |
| Charger | $40 to $100 |
| Drill and impact driver combo kit (2 batteries, charger) | $150 to $250 |
| Bare tool (no battery), when you already own the brand | often $80 to $250 less than the kit |
Approximate prices, November 2026. Watch for sales that include a free battery or tool.
Our take
- Start cordless with a drill and impact driver kit, and stay with that battery brand.
- Add cordless saws, a nailer and a multi-tool as you need them: the convenience is worth it.
- Buy corded for tools that stay put and run long: table saw, miter saw, sander, shop vac, and a big hammer drill if you do a lot of concrete.
- Keep at least two packs charged for any serious job, and one extra in cold weather.
- Away from power for days at a time? Battery tools plus a generator or solar to recharge them is the most flexible kit.
Prices are typical U.S. store prices checked November 17, 2026. They change often with sales; check the store. Tools Critical is not paid by any store or brand.